Hot Cam Dyno Results
#1
10 Second Club
Thread Starter
iTrader: (4)
Join Date: Feb 2004
Location: Marysville, WA
Posts: 9,448
Likes: 0
Received 0 Likes
on
0 Posts
Hot Cam Dyno Results
I just got back from dynoing my car, and while I did not hit the 400 mark I was aiming for, I got pretty close.
391.2rwhp, 371.0rwtq SAE (396.5 & 376 actual)
Not too bad for a cam only car with an A4!
Now I need to go install my 4.10s (today) & a stall (later) & see if I can run 11s.
391.2rwhp, 371.0rwtq SAE (396.5 & 376 actual)
Not too bad for a cam only car with an A4!
Now I need to go install my 4.10s (today) & a stall (later) & see if I can run 11s.
#7
10 Second Club
Thread Starter
iTrader: (4)
Join Date: Feb 2004
Location: Marysville, WA
Posts: 9,448
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys, I was pretty happy. I tried scanning my graph in to post, but I was suffering from operator error. I'll keep trying. Basically the tq is pretty flat up to 5k & then starts tailing off. The hp increase just about doubles at 4k, starts to slow down at 5500, and peaks right around 6200-6300 & is flat to 6400 where I had the rev limiter set. I did not get an a/f chart. I need to ask them if they took the reading.
And I might have #s that come close to your 71 Racehead, but you have that nasty-cammed, BBC sound that my car will never have.
And I might have #s that come close to your 71 Racehead, but you have that nasty-cammed, BBC sound that my car will never have.