stock replacements????
01-27-2005, 07:43 PM
#1
Possible Scammer - Buyer Beware - Issues Unresolved
Thread Starter
iTrader: (8)
Join Date: Apr 2004
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
stock replacements???? i am wanting to forge my bottom end. would these be pretty much stock replacements?
Mahle Motorsport Forged 346 cid LS1 Flat-Top Piston Set: 3.903" Bore, 3.622" Stroke, 6.125" Rod Length, .927" Wrist Pins, 1.340" CH, -1cc Dish; Wrist Pins and Piston Rings Included (off TSP)
doug
Mahle Motorsport Forged 346 cid LS1 Flat-Top Piston Set: 3.903" Bore, 3.622" Stroke, 6.125" Rod Length, .927" Wrist Pins, 1.340" CH, -1cc Dish; Wrist Pins and Piston Rings Included (off TSP)
doug
Last edited by 00ls1; 01-27-2005 at 07:48 PM.
01-27-2005, 10:06 PM
#2
those are setup for a bore thats been honed. also the compression height looks to big for a 6.125 rod, you'll be sticking way out the deck.
im using a 3.905 diamond piston, .927 wrist pin with a 1.309 CH and a 6.125 eagle rod
and
@ your sig, what thread was that, i dont remember off hand.
im using a 3.905 diamond piston, .927 wrist pin with a 1.309 CH and a 6.125 eagle rod
and
@ your sig, what thread was that, i dont remember off hand.
01-27-2005, 10:50 PM
#3
Possible Scammer - Buyer Beware - Issues Unresolved
Thread Starter
iTrader: (8)
Join Date: Apr 2004
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by jrp
and
@ your sig, what thread was that, i dont remember off hand.
