1998TA__1991RS

iTrader: (23)

my converter has been acting up lately (vig 2800) it will lockup and unlock really quickly when the tranny is cold but once it warms up it doesnt do it. i put a new lockup solenoid in it but it didnt help much, my tuner said it wasnt in the tuning, what else can it be??? i called precision and they said it would either be one of the two.

Rock-On

iTrader: (-2)

Check the rubber o-ring on the end of the input shaft...a leaking seal will cause the situation your talking about.... Hope this helps...Dave

1998TA__1991RS

iTrader: (23)

so i have to pull the tranny out or just the pan off?

Rock-On

iTrader: (-2)

Pull the tranny, it's on the input shaft.......do you have a transgo installed? Is this a built transmission?? which solenoid was replaced?? ....Theres two ..PWM, and lockup.....Hope this helps...Dave

1998TA__1991RS

iTrader: (23)

its fully built, trans-go kit, corvette servos, everything was redone,

Rock-On

iTrader: (-2)

you mentioned a new lock up solenoid...there are two associated with lock up.......which one was replaced???? relly need this info.....to help you out....hope this helps Dave