Manual Transmission - quick LT-1 clutch fork question

I may have a bent fork, can someone tell me the correct depth on the slave cylinder end of the fork? Measuring from the flat surface of the back of the bell housing, how deep should the face of the fork be? (not the pocket depth, just the cast surface of the fork arround the pocket)

I may have a bent fork, can someone tell me the correct depth on the slave cylinder end of the fork? Measuring from the flat surface of the back of the bell housing, how deep should the face of the fork be? (not the pocket depth, just the cast surface of the fork arround the pocket)

I wish someone could answer that I got the same problem with my buddies car.