TCI ssf 3500
#1
11 Second Club
Thread Starter
Join Date: Jun 2005
Location: Syracuse In
Posts: 481
Likes: 0
Received 0 Likes
on
0 Posts
TCI ssf 3500
My only question is simple. I haven't installed this yet, Just wonding sense i just can't wait to find out. Is on stock brakes and BF Dr how high am I going to be able to launch. Stock engine to only few free mods and I do spray but That shouldn't be an issue here. I just love Launching and would like to know how This setup works for you guys in yours I'll have mine in about a week in my car. Thanks
#7
Originally Posted by ls_101
3100-3200 street tires, with new brake pads around 3400 on dr's
Trending Topics
#9
Originally Posted by EDALVA21
Did you'll get the cars tuned before you'll saw those results?
#10
12 Second Club
Join Date: Jan 2005
Location: In the big city of Houston and big state of Texas.
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
My car doesnt seem to hook and when stopped at a stop light the rpms goes anywhere from 500 to 700 up and down, up and down. Thats why I was wondering if I had to tune the car for it.
#11
11 Second Club
Thread Starter
Join Date: Jun 2005
Location: Syracuse In
Posts: 481
Likes: 0
Received 0 Likes
on
0 Posts
Well I didn't expect you would all say about 1/2 sec That would be great Might just put me at 13.00 That would be cool. Anyways thanks for The ideas i'll post up When i get it in hoply before I go to the Track on the 8Th Now all i need is For it to get to my house so i can put it in
#12
Originally Posted by Z'mnypit
How do you leave at 3100-3200? I have the ssf3500 & cant stall it past 2200 on et streets.
honestly i dont know, i stall up and it launches hard, 2200 on et streets wow, u might want to check the trans and convo, also make sure ur brake pads are like new, i have brand new pads and rotors all around and front calipers as well, u need reall good brakes, i also have a alum driveshaft
#13
11 Second Club
I don't think I could stall my SSF3500 to 3k or above. Actually, my now restalled SSF4000 spins the nittos over not too far above 3000. I launch from ~2900 at the track thus far. (SSF4000)
#14
10 Second Club
iTrader: (12)
Join Date: Dec 2004
Location: Birmingham, Alabama
Posts: 2,034
Likes: 0
Received 0 Likes
on
0 Posts
Most guys I know will only bring the rpms up to like 1500 or so.. Even if they have a 3800stall. That way it gets the slack out of the suspension and rear end and when you come off the brake and floor it the converter will flash up high and give you that extra "kick" out of the hole..
#15
11 Second Club
Originally Posted by 1QuickT-A
Most guys I know will only bring the rpms up to like 1500 or so.. Even if they have a 3800stall. That way it gets the slack out of the suspension and rear end and when you come off the brake and floor it the converter will flash up high and give you that extra "kick" out of the hole..