starting slave cylinder swap
10-06-2005, 09:21 PM
#1
Teching In
Thread Starter
Join Date: Sep 2005
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
starting slave cylinder swap I'm starting a slave cylinder swap on Saturday morning. I have a 98 Z28. Per the advice from someone on this forum, I purchased an 01 slave cylinder.
Here's the thread on that:
https://ls1tech.com/forums/manual-transmission/375583-clutch-going-floor.html
Does anyone have some dos and don'ts for this job? Anyone happen to know the torque specs on bolts holding the transmission to the engine?
Any comments would be welcome.
Kind Regards,
Israel
Here's the thread on that:
https://ls1tech.com/forums/manual-transmission/375583-clutch-going-floor.html
Does anyone have some dos and don'ts for this job? Anyone happen to know the torque specs on bolts holding the transmission to the engine?
Any comments would be welcome.
Kind Regards,
Israel
10-18-2005, 02:27 AM
#2
Staging Lane
iTrader: (1)
Join Date: Apr 2005
Location: Chicago
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
I think it might help me too!! ttt
I hope somebody has some info I might be doing this in the near future plus the ram adjustable. Pedal engages 1/2 off the floor shifts are really stiff bleed the thing crazy it helped but only for awhile.
I hope somebody has some info I might be doing this in the near future plus the ram adjustable. Pedal engages 1/2 off the floor shifts are really stiff bleed the thing crazy it helped but only for awhile.