Picture of my B&M Hammer Shifter in M6 console.
10-30-2005, 08:09 AM
#3
Teching In
iTrader: (1)
Join Date: Aug 2005
Location: South West Ohio
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Looks good. Do you have any details to share? Example : What did you do about the M6 shifter hole in the tunnel? Did you have to trim the console any? What part # did you use?
10-30-2005, 09:47 PM
#5
10 Second Club
Thread Starter
iTrader: (11)
Join Date: Dec 2003
Location: Joplin, Missouri
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Hugh betcha
Looks good. Do you have any details to share? Example : What did you do about the M6 shifter hole in the tunnel? Did you have to trim the console any? What part # did you use?
10-30-2005, 09:50 PM
#6
10 Second Club
Thread Starter
iTrader: (11)
Join Date: Dec 2003
Location: Joplin, Missouri
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by LS69TA
Looks good. I'm thinking about putting a Megashifter I've got laying around in the T/A. Did you use the new cable or the factory one?
10-30-2005, 10:11 PM
#7
TECH Fanatic
Join Date: Jul 2005
Location: Dallas
Posts: 1,243
Likes: 0
Received 0 Likes
on
0 Posts
That looks badass man! good job 
Man i wish i could rig up a similar setup with my 4l60e. It seems no one makes aftermarket shifters for these things, let alone one that would fit in an M6 console with minor modification.
Man i wish i could rig up a similar setup with my 4l60e. It seems no one makes aftermarket shifters for these things, let alone one that would fit in an M6 console with minor modification.
