rescreening a maf sensor
11-14-2005, 09:09 AM
#1
Staging Lane
Thread Starter
Join Date: Aug 2002
Location: Raleigh,NC
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
rescreening a maf sensor I plan on putting my stock maf sensor back on (removing a slp 85mm) and i have removed the screen .When i removed it i carefully cut it out and believe it is good enough to put back in.My question is what would you use to reglue it----super glue,,epoxy..what???.
11-14-2005, 01:41 PM
#2
TECH Fanatic
iTrader: (6)
Join Date: Nov 2001
Location: NV
Posts: 1,224
Likes: 0
Received 0 Likes
on
0 Posts
Me personally,I wouldn't try to put it back in.I had mine desreened/ported and went back to a stock one.You would think any kind of glue/epoxy would skew the readings.Since the screen is there to straighten the air flow.Plus if what you use doesn't hold,it would get sucked into the wires.
I think your better off getting a new one or finding one used that someone has.
I think your better off getting a new one or finding one used that someone has.
11-14-2005, 03:56 PM
#3
TECH Resident
iTrader: (22)
Join Date: Feb 2005
Location: Phoenix, AZ
Posts: 907
Likes: 0
Received 0 Likes
on
0 Posts
Agreed. Just learn from your mistakes and get a new one. Make sure to match your exact year, and don't go the e-bay route. Just take the hit to the wallet and walk camly down to your nearest GM parts dealer.
And remember the saying "Dont touch my MAF!"
And remember the saying "Dont touch my MAF!"
