Pulley and intercooler help
#1
TECH Regular
Thread Starter
iTrader: (21)
Join Date: Oct 2005
Location: Santa Barbara, California
Posts: 479
Likes: 0
Received 0 Likes
on
0 Posts
Pulley and intercooler help
I'm looking for opinions/suggestions for a pulley for my setup. Stock rear stock block with mods awaiting install listed in my sig below. i'm afraid the stock 6psi pulley won't be enough. Also can you purchase the ati intercooler kits seperate? i need an intercooler setup and like the ATI. help a brotha out.
#2
The ATI ProCharger twin high flow 4.5" twin intercoolers and plumbing are approx $1,000.00 and some change. There are quite a few people who are switching over from the twin high flow intercoolers to a large front mount, you should be able to pick up a used combo on this forum.
If that 6 psi Powerdyne pulley is based on a stock engine, you'll be lucky to make 4 psi with your mods. You are definately going to need a smaller pulley! Bob
If that 6 psi Powerdyne pulley is based on a stock engine, you'll be lucky to make 4 psi with your mods. You are definately going to need a smaller pulley! Bob