How should I Fab up TD's with this X-pipe?
#1
TECH Resident
Thread Starter
iTrader: (2)
Join Date: Jul 2004
Location: Appleton Wi
Posts: 894
Likes: 0
Received 0 Likes
on
0 Posts
How should I Fab up TD's with this X-pipe?
Anyone used this x-pipe and fabbed up TD's dumped? How should I go about doing this seeing how the x-pipe is parallel and does not have 45 degree bends? YThe Pricew was so attractive I just ordered it without thinking about it.
I am thinking about trying to modify my ORY
Any Ideas Guys?
I am thinking about trying to modify my ORY
Any Ideas Guys?
Last edited by Uno99; 11-18-2005 at 06:27 PM.
#5
TECH Resident
iTrader: (1)
Join Date: Nov 2001
Location: Vertigo
Posts: 955
Likes: 0
Received 0 Likes
on
0 Posts
With the extra work/bends/money you'll need to make that X work, you might as well punt now... I really like the Magnaflow X, but it's just too big and isn't angled right to work in the tight area under an F-body. Especially if that's the huge 3" one it looks like it is...
Good luck.
Good luck.