dkbmxer002

iTrader: (5)

i have a tci 3000 stall sitting on my floor. and i was wondering if when i install it i will bounce off the rev limiter. i am spraying a 125 shot and have a friend who is dealing with this problem. so i was curious if all the stall's do that on spray or just some or what. and what would be the best way to prevent it?

meSSman02

Four buddies of mine have 02 ss all have 3000 or better stalls in them with 100 shot or better they all have tuned ther transmission for the spray and stall so this will not happen. Key word is TUNE before you spray or this might happen

dkbmxer002

iTrader: (5)

yea i have a friend with hptune and such. what exactly do i wanna change? is there a place to get the right specs?

meSSman02

It would be best to find sombody repeutable in your area to have a dyno trune performed . is your verter set up for nitrous?

dkbmxer002

iTrader: (5)

what do you mean is it setup for nitrous? i baught it from a guy who was spraying on it.... so i believe so

dkbmxer002

iTrader: (5)

anyone else have an opinion on this?

Cheater

iTrader: (7)

not to talk about these guys but i had a tune with cam only then put a stall later after the cam and my car runs ok

dkbmxer002

iTrader: (5)

can you define running ok?

The Sad

iTrader: (8)

I'm not sure about on the juice, but I think with that low a stall you would be OK. I never had problems with my Midwest 3200, but I wasn't spraying either.

But getting a tune really helped the feel/shifts of the tranny.

BORN2LOSE

You'll be fine with that converter. But like everyone else said, get it tuned.