anotherreject04

iTrader: (4)

where have you guys mounted your electric cutout switch....im getting my longtubes, ory, and cutout installed tommorow so any help or ideas soon would be great

Sgt. Spuds

iTrader: (1)

on the side of the drivers seat.

SgtB

iTrader: (3)

on the drivers side of the center console down by where my knee is

Swang

iTrader: (3)

where would be a good place to drill it in if you dont want a switch to be obvious?

Kenafin_02TA

In the same panel as my TCS switch. Drilled right through the center of the Pontic arrow....

slow trap

iTrader: (22)

i put mine in my ash tray where my nitrous stuff is. alittle more cramped in there now but atleast it's out of the way.only down side is i've got it hooked up on my arming switch so i have to arm the nitrous to open her up

chewy99ws6

iTrader: (8)

I put mine between the cupholder and gear shifter, I wanted to put it between my TCS and my top switch but that is where I put my line lock. The switch were too deep to fit in the ashtray.

My2ndls1

iTrader: (3)

I mounted mine just below the cigarette lighter. With my short shifter, I don't even have to take my hand off the shifter to open/close it. Plenty of room also!

bastien

iTrader: (1)

convert switch next to my TCS

99 bad aSS

iTrader: (3)

Another for the ashtry.

Eatinstang4life

iTrader: (10)

If you do not smoke take the ash tray out and mount it where the ashtray goes or you could moount it in your ashtray if you wanted it is a good spot to hide it

anotherreject04

iTrader: (4)

im getting it under the dash to the left of the steering wheel

SgtB

iTrader: (3)

how about delete the tcs and use the factory tcs swith

bastien

iTrader: (1)

you can't use the factory TCS switch.

nbr01f

Where the truck release button is (For those without truck release or dont use it)

Z28LS1camaroguy

iTrader: (3)

would this work just like it is, http://texas-speed.com/shop/item.asp?itemid=21&catid=31
i heard you have to do something for it to work and be able to hook the cutout to it. it would fit in the cell phone holder and its kind of factory looking, anyone else have this switch panel with there cutout as one of them???