darbydarby

Almost ready to put the 9" under the car but have run into a problem.


there are 2 axle housing seals,that the instructions say nothing about.

We can see the recessed area where they belong, but after putting them in,putting the axles in and tightening the 4 bolts on the end up the axles/rear wont turn.

when the seals werent in and we had everything tightened up everything turned just fine.As far as we can see the seals are in as far as they can go so were kinda walking around in the dark here trying to figure something out.


its sunday,so we can ask moser what we need to do.......Hopefully one of you fellas can help.


thanks

ninobrn99

iTrader: (8)

TTT for ya..im about to work on installing mine today and tomorrow...good luck!!

Moparnos (The SLP Guy)

iTrader: (55)

mine was hard to turn too but after puting in gear lube in and spinning it. it was all good

badpewter-z

iTrader: (4)

mine were hard to turn too after i re-assembled it but if you turn the yoke it should all turn fine.

co.6z28

iTrader: (1)

ttt havin the same problem

BADSZ28

iTrader: (39)

Did you guys throw some lube on the seals prior to installing the alxes? I did and did not have this problem.