KurtRardin

iTrader: (11)

I am looking into buying a moser 9" from one of our sponsors for $950, because i am on a budget and my goal of 400rwhp tells me that i will waste money if i drop the other $1500 just on the moser center. Who builds a decent center section around here? I want 31 spline, detroit locker, 4.11s, 1330 or 1350 yoke. I thought i had a guy to build one for $650, but now hes banned. Who would offer a package deal with a "house" 3rd member?

Nittany_marine

iTrader: (7)

Pm sent your way, devil dog. Semper Fi.

00sscam

I can tell you i have been more then happy with my 9" it was bult by DLS Scott is top notch he hooked me up with a complet 9" setup and i have no problems dead quiet and rear has taken quite a bit of abuse. Give him a call.

BlackLine

iTrader: (1)

im also interested in a center section around that price.

i found the axles and housings for around 900 is there anything else needed besides the center section?

mike2244

iTrader: (2)

go with a 12 bolt cause the 9 in is going to rob hp. with 400 rwhp all you need is a 12 bolt. that is my 2cents.

Nittany_marine

iTrader: (7)

I thought the same thing, until I heard about so many guys getting a lot of whine, and such after going with a 12 bolt instead of a 9". I say go with the 9" and forget about it. I went with DLS too, and Scott was great.

BlackLine

iTrader: (1)

who is DLS?

KurtRardin

iTrader: (11)

http://www.driveline-solutions.com/scart/agora.cgi

KurtRardin

iTrader: (11)

I've also heard that moser doesnt know how to set up gears properly. You would think that with all those tools there at their disposal that there wouldnt be a single complaint about things like ring gears not being bolted in but finger tight. I dont want to have to take a rear end to someone and pay to have it set up after i just dropped almost 2.5k on one. Rediculous.

camarokid94

iTrader: (2)

umm.... my moser 9IN whines....
but im ok with this