Factory oil pressure sender thread size. (Need adaptor)
02-09-2006, 08:25 PM
#1
TECH Enthusiast
Thread Starter
Join Date: Nov 2002
Location: Michigan, auburn HIlls
Posts: 550
Likes: 0
Received 0 Likes
on
0 Posts
Factory oil pressure sender thread size. (Need adaptor) I am running a autometer mechanical oil pressure gauge. I want to use the hole behind the intake manifold that the factory sensor uses.
Do you know what size thread etc this hole is. Does anyone sell an adaptor.
Do you know what size thread etc this hole is. Does anyone sell an adaptor.
02-09-2006, 08:46 PM
#2
its either 10mm or 12mm
summit and jegs carries the autometer adapters.
im sure it will come up in a search.
you might need a T, as the factory unit needs to be working in order for the fuel pump to work, unless you wired it around the ecm somehow.
good luck.
summit and jegs carries the autometer adapters.
im sure it will come up in a search.
you might need a T, as the factory unit needs to be working in order for the fuel pump to work, unless you wired it around the ecm somehow.
good luck.
