BIG_MIKE2005

iTrader: (116)

I was going to get Air/Fuel, Fuel Pressure, & Nitrous. But I decided I am goin to build another motor for nitrous & just run this one N/A.

So what gauges would be best for me???
I was thinking maybe Oil Pressure, Water Temp., & Tranny temp. Although some have told me there is no use for a tranny temp. gauge in a M6.

Any other seasoned guys in here have suggestions. All gauges will have to be electric. I am also wanting to use the Autometer Ultra lite series.

Thankx for any information. I am tryin to order these by the end of the week.

Jabroni

FWIW, I went with fuel pressure and H20 temp. I don't trust the stock temp gauge as it is anyway.

ROCNDAV

iTrader: (100)

Yup I'm looking at Oil Press, Water temp & Fuel Pressure

BIG_MIKE2005

iTrader: (116)

Just talked to Jon & have decided to go with one of a couple set-ups.

(1) Water Temp. - Oil Pressure - Oil Temp.
(2) Water Temp. - Oil Pressure - Fuel Pressure
(3) Water Temp. - Oil Pressure - Air/Fuel(to monitor O2 sensors only)

black00TA

iTrader: (3)

i use air/fuel and oil temp. if i had went with three it most likely would have been water temp.

GR33N GoblinM6

iTrader: (14)

Air/fuel isnt really accurate at all.. unless you get one of those AEM ones that uses a wideband..

i going to get the Aeroforce gauge.. i have oil temp & trans temp..

you2slo

+1 for the Aeroforce Interceptor guages. Plus it's an easy install...just plug into the OBDII port.

black00TA

iTrader: (3)

yes i agree, the stock 1v sensor is not accurate in the least bit.

i got the aeroforcetech gauge on my wishlist

BIG_MIKE2005

iTrader: (116)

Well I decided to go with my above option #1.

Oil Temp. - Oil Pressure - Water Temp.
I will also be puttin my harlan shift light in the a-pillar, so pics will be posted in the appearance section when its done.