LS1TECH - Camaro and Firebird Forum Discussion

Generation III External Engine LS1 | LS6 | Bolt-Ons | Intakes | Exhaust | Ignition | Accessories
Sponsored by:
Sponsored by:

O2 Question - Heat protector boot on wire

Thread Tools
 
Search this Thread
 
Old 02-26-2006, 03:04 PM
  #1  
JGA
TECH Enthusiast
Thread Starter
 
JGA's Avatar
 
Join Date: Feb 2005
Posts: 563
Likes: 0
Received 0 Likes on 0 Posts
Default O2 Question - Heat protector boot on wire
Hi

Does anyone know if the small silicone boot on the aftermarket O2s is as good as the heavy braided boot on the OE O2s?

I have some new NGK pre-cat O2s to install, but I have noticed they have a much smaller silicone boot covering the wires.

Thanks JA
JGA is offline  
Reply Like
Old 02-26-2006, 06:57 PM
  #2  
Launching!
iTrader: (7)
 
BlutVonSchwachen's Avatar
 
Join Date: Sep 2004
Location: Denver, CO
Posts: 290
Likes: 0
Received 1 Like on 1 Post

Default
Should be safe to use. Just tie them up away from your exhaust and you should be fine.
BlutVonSchwachen is offline  
Reply Like
Old 02-26-2006, 07:20 PM
  #3  
JGA
TECH Enthusiast
Thread Starter
 
JGA's Avatar
 
Join Date: Feb 2005
Posts: 563
Likes: 0
Received 0 Likes on 0 Posts
Default
Originally Posted by BlutVonSchwachen
Should be safe to use. Just tie them up away from your exhaust and you should be fine.
Thanks
JA
JGA is offline  
Reply Like
Back to Subforum
Generation III External Engine
View Next Unread
Intake question




Advanced Search

All times are GMT -5. The time now is 05:18 PM.