Ping King

iTrader: (20)

Im trying to make a set of plug wires for my ls1 car. I need to know the msd part number for the boots and terminals that will fit the coil packs....im using 8.5 wires.

any help would really be appreciated.

you2slo

Why are you not using prewired LS1 specific wires? Just wondering.

SUTTERERMAN85

iTrader: (42)

their not that expensive...

Ping King

iTrader: (20)

i have foward swept turbo headers heheh...they wont fit....i need to run the wires differently and relocate the coil packs.

dailydriver

I think Jay Fisher Pontiac had some sets of Moroso Ultra 40s made up for coil pack relocation setups. I don't recall how much $$ they were though.

Luna

iTrader: (6)

I think LT1 wires are often used in custom coil pack relocation jobs but I am not positive if they will work , just something I thought I rememberd reading someplace

you2slo

Check out Thunder Racing. They sell longer wires for coil relocation. I don't know if they would be long enough to clear everything for you.

Ping King

iTrader: (20)

thanks guys....i actually have 25 ft of msd 8.5 wire...and the boots for the plugs.

i was just wondering if the coil packs take a standard boot or is it somthing special.

ArKay99

iTrader: (1)

This is the same thing I'm trying to do. I have a set of the standard MSD Superconductor 8.5mm wires on there now. Those wires use the AC Delco coil boot. They must use those for the angle and fit. I don't know if anybody makes a coil boot for the LS1 coil. If they do I'd be on it too.

frey51

I was just going to say the same thing. The MSD wires do use the stock AC Delco boot. When I got my 8.5's I thought it was a little screwy that you have a high performance wire with one boot that isnt as suseptable to heat, and a stock one. I would think that MSD would have at least done some reverse engineering to get a boot that they make, rather than using the delco parts bin.

Fry

Ping King

iTrader: (20)

oh boy...well if worse comes to worse ill have to use Delco boots and terminals.