Biochem

Does anyone know where a good place to plug into the TPS wire is for a clean install? TIA

860 Performance

iTrader: (1)

I usually tap the wire near the TB. Then run it through the factory harness over the motor.

Matt@HSW

iTrader: (14)

Another option would be at the PCM (Red Connector on PCM, pin 24, Dark Blue Wire).

Matt

terry s

iTrader: (5)

No cutting or splicing required.

Caspers Electronics is making me a plug in wiring harness for my Z06 with a pigtail for the TPS wire. Justin over there was great to work with.

I will then put a single wire GM weather-pack connector on the pigtail.

Nitro Dave's Nitrous Outlet

iTrader: (25)

Now thats pimp..
Dave

terry s

iTrader: (5)

Dave: I told you Carper's has some neat stuff. Don't give up on me yet. I'll get this nitrous set up going one of these days. Actually I am getting pretty close.

Nitro Dave's Nitrous Outlet

iTrader: (25)

Terry,
Yes I have been meaning to check them out. Ill put it oin my to do list.
When you spray it will be all worth it..
Dave