New NX Sytem...Any Advice?
#1
On The Tree
Thread Starter
Join Date: Dec 2005
Location: Tomball, Tx
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
New NX Sytem...Any Advice?
Hey guys. I've been a member on her for a while but haven't posted much due to being in Iraq for a while. I recently took advantage of a deal a guy threw at me due to getting a divorce. I stole a complete NX NXL sytem good to 180 shot with accessory kit ie. purge kit, bottle heater, remote bottle opener, and everything else to the kit for $650. The kit is brand new and had never been taken out of the packaging. I have a 99 T/A that the rings were going on. I don't have a lot of money so I am going through the shortblock and forging it (can't afford a stroker at this moment). I am however going to install cam, stall, gears, Lt's, and ORY when it goes back together. Any advice would be appreciated as all of my nitrous experience has been on single plane carb'd vehicles not EFI. Also if someone could tell me how to post pics I will as I have already put the system on the intake and am just waiting to get the rest of the motor finished up.
#2
TECH Senior Member
iTrader: (23)
Join Date: Aug 2005
Location: Watertown, NY
Posts: 8,797
Likes: 0
Received 0 Likes
on
0 Posts
Follow the install instructions and be sure to have an adequate fuel system and nitrous safety devices hooked up. On a forged setup you can run a huge shot with tuning and the fuel system to support it.
#3
On The Tree
Thread Starter
Join Date: Dec 2005
Location: Tomball, Tx
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
Thanks. I live in Houston so I am at the hands of a few different places as far as a tune goes ( MTI, HPE, and so forth). Anyone have any opinions on how there tunes are. I want someone who is going to do the absolute best they can do on this tune and not just tune it ok and say there you go.
#4
TECH Senior Member
iTrader: (23)
Join Date: Aug 2005
Location: Watertown, NY
Posts: 8,797
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by 99T/A
Thanks. I live in Houston so I am at the hands of a few different places as far as a tune goes ( MTI, HPE, and so forth). Anyone have any opinions on how there tunes are. I want someone who is going to do the absolute best they can do on this tune and not just tune it ok and say there you go.