Nitrous Oxide - Just ordered the plate from Dave

Sent an email on Friday to order the plate for my Z06. Hopefully I can get it installed before Colorado Track Day on May 10th. I'll post results. I might run tomorrow with the current setup for a baseline. If I don't, I'll dyno it. With the new clutch and line lock, I should be able to dip into the 11s. It's a little harder up here a mile high... :cry:

At sea level, I'd be closer to 10s.

Anyway, looking forward to the plate. I may rethink my plumbing setup later this season. It's tempting to get the standalone fuel setup and go with a bigger progressive shot... We'll see how close it gets to the 11.5 limit with the plate. I don't really want to put in a roll bar, anyway.

Tony
Get a pull NA with the plate installed. I've seen post where guys have picked a few ponies just from the plate. :confused:
I'm planning on getting one for my car to replace my single fogger setup. A few extra hp from just the plate would be a cool bonus.

May 6th I will have numbers for a stock Vette and the plate (as well as Plate vs Dry).

cool. i got my plate on and pretty much wired up. installing plugs right now but im forced to wait and order new wires from the mainland as noone has them in stock and the dealers are closed.

chris got a pic of what you did for the fuel noid? Looking for ideas.

Beer

chris got a pic of what you did for the fuel noid? Looking for ideas.

Beer

some quickie pics in the dark garage promised dave i would get some of all the work so these are teasers :) . there is no bracket for the fuel noid yet but thats how its going to be mounted. still cant decide if im going to drill & tap the alternater bracket.
http://img157.imageshack.us/img157/673/dscf00301lx.jpg
http://img157.imageshack.us/img157/8418/dscf00316em.jpg
http://img157.imageshack.us/img157/3131/dscf00322ht.jpg

Thanks chris, I am toying with fabbing something from the PS reservoir bolts or the intake/ coil pack bolts, will be doing that Monday or Tuesday. I will post pics when I get them. The Nitrous Noid location looks the same as I am doing.

hopefully mine gets here soon...

Can you order the plate by itself? I saw where it was included in a kit, but couldn't find just the plate. Also, can you use standard jets?

look for the plate conversion on their website. It comes with jets. Ranges from $225 to ~$290 depending on single or two stage. Call them.

Can you order the plate by itself? I saw where it was included in a kit, but couldn't find just the plate. Also, can you use standard jets?

Yup. just call em up and tell em you want only the plate. It comes with with jets as well. Hope this helps. I wish they were open now because I am chomping at the bits sitting here waiting to order my progressive controller. I feel like Beavis when he got geeked out on caffeine and sugar!!! :eek2: Are you threatening me, are you threatening the great Cornholio!!!??? :jest:

Jim C.

Hey guys. Thanks for all your support. Its amazing at how many of these plates are out there. Everyone has had really good feed back.

Chris your install is looking good.
Dave