how much for procharger installed
05-28-2006, 10:30 AM
#1
TECH Regular
Thread Starter
iTrader: (1)
Join Date: Feb 2006
Location: Katy,Texas...
Posts: 432
Likes: 0
Received 0 Likes
on
0 Posts
how much for procharger installed if i wanted to make around 500 rwhp with a procharger kit that wouldnt hurt my stock bottom end....
which kit and how mch would it cost installed (estimate)
which kit and how mch would it cost installed (estimate)
05-28-2006, 12:59 PM
#3
Staging Lane
iTrader: (5)
Join Date: May 2006
Location: Michigan/ Tennessee
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Well if you procharge go D1SC and you will get the most power, and it is better for the money VS the P1SC. All you will need is pistions and rods and nothing more for the bottem end. I advise you not to go with the dual intercooler steup, go one big one and buy a blow off valve seperate and the kit is about $5,200 not installed! If money is a factor buy the head unit and make the pipeing your self.( That is what i am doing but i am not done.) And when your all said and done you will have atleast 580 at 8 to 10 pounds of boost, then the trans and rear end become a problem! I read about an SS running same setup but with a full suspension running 834rwhp and 9.80s!
05-28-2006, 05:32 PM
#4
I agree, get the D1SC as you will very likely regrett not doing so down the line. Exotic Performance Plus on here is the place to go for prochargers. Bob is on here alot giving support and they know what they are doing as proven by many that have dealt with them on here in the past. Bob at EPP + D1SC = road to happyness!
05-28-2006, 07:41 PM
#5
BOSS APPROVED!
D1SC and a FMIC should get you 500 rwhp @ 10 psi give or take some ponies. Make sure that you have plenty of money in savings, because the easy part is the horsepower. Its everything else that comes with it that will break the bank (tranny, rear end, SDCE, etc, etc).
