Z 2 L8ter

iTrader: (6)

I installed the pulley about a month ago and decided to fire the car up the other day just to listen to it run. When it turned on the check gages light was on also. I went outside and saw the bigger belt that goes around the water etc. had flown right off. I put it on again and it worked fine. Has anyone else had any problems with their belts coming off with this pulley?

Thanks,
Jeremy

Jabroni

If the balancer pulley is seated completely, I'd be looking at the tensioner pulley up top. I think I read here before about something called a "Larry pulley" that has a higher lip edge for the tensioner which will help the belt track. Do a search for a larry pulley and see if the thread pops up. In short, this has been an issue before.

DaddySS

You may have just had a problem where the belt stuck to the pulley because it was sitting? If it's tight and aligned it should not come off.