Trying to fit my 325 MT DR's
#1
Trying to fit my 325 MT DR's
Well, i have 15X10 prostars with 7.5in backspacing and 325/50/15 DR's on them.
I bolted them up and the bumpstop mount (actual bumpstop is removed) sticks right into the side of the tire.. anyone else have this problem? There is no load on the rear end, the car is sitting on 4 jack stands on the subframe connectors.
I could not get the wheel to turn at all.. but that could be because i have a tad bit more grinding to do, but when i took the wheel off, there was a bump stop imprint on the side of the tire.
I have clearanced inside the fender wheel already, i don't think that is my problem. Any help?
I bolted them up and the bumpstop mount (actual bumpstop is removed) sticks right into the side of the tire.. anyone else have this problem? There is no load on the rear end, the car is sitting on 4 jack stands on the subframe connectors.
I could not get the wheel to turn at all.. but that could be because i have a tad bit more grinding to do, but when i took the wheel off, there was a bump stop imprint on the side of the tire.
I have clearanced inside the fender wheel already, i don't think that is my problem. Any help?