c5_ls1_6spd

iTrader: (-1)

anyone dyno this combo to the rear wheels?

300bhp/ton

I've not seen any yet, but a lot say they have just ordered it. I think TSP posted some numbers for a LS2 with that setup.

I would expect 440+rwhp with a resonable spread across the powerband. Not the ultimate, but it's fantastc $/HP

lt1formula2000

iTrader: (10)

I've seen where a few people on here have oredered this setup, I doubt any of them are done with the install yet. I would also like to know the results as I plan to order this sometime this summer. this looks like a one of the better bang for the buck setups

damn 300bhp beat me to it

99T/A

Just got off of the phone with Brian @ TSP. He said my heads should be ready no later than the beginning of next week and everything will be on the way to me. I should have the shortblock back today or tommorrow so when I get my stuff in it should only be a few days till it's up and running. That is the MS4 and PRC CNC Ported LS6 heads.

Chris

Superjoe

iTrader: (2)

I should be receiving my MS4 package next monday. I'll be running it on a totally stock motor with LT's and catback. It dyno'd at 333rwhp/334rwtq with those two, so I will post the gains with the cam alone on a stock motor. So far I think most everyone else with the MS4 is doing heads too, this ought to be a good test of the cams original claims against a stock motor.

Photochop

iTrader: (74)

I'm sure the numbers will be very good considering the development of this cam was semi-based around the ported heads they offer. I'm very eager to see what the ms4 cam does with the heads...I would imagine the torque numbers will be higher than previous cams of similar size.

JoeyGC5

iTrader: (24)

Hopefully dynoing by the end of next week With a LS2/Fast 90 and TSP long tubes.

CraZee ZO6

Very interested also.
Im going to see how the ms4 works with my stock LS6 heads and spray. Hoping for 450rwhp n/a.

stealth71

iTrader: (15)

I guess I will wait and order after you all have tested the combo. Thanks for the R&D.