lastcall190

iTrader: (36)

I'm at my wits end right now with the removal of my loudmouth... the pipes are crimped where the clamps went on, and besides beating the everliving **** out of it, are their any civil ways to remove it? The damned i-pipe to over the axle connection is what's holding me up. I am ready to just cut the damn **** at this point, any suggestions?

Full-Force

iTrader: (11)

Might as well cut it because if a ring clamp was used to secure it then it aint coming off by hand.

00454sscamaro

do you know if it was welded? i had to weld mine for it to keep from blowing off at the area your talking about.

lastcall190

iTrader: (36)

I just cut it Thanks anyways, one more reason I'm happy to be going with TDs at this point...

-J

HeapaShifter

iTrader: (2)

I had to cut my loudmouth off too.