Generation III External Engine LS1 | LS6 | Bolt-Ons | Intakes | Exhaust | Ignition | Accessories
Sponsored by:
Sponsored by:

another duals question

Thread Tools
 
Search this Thread
 
Old 07-17-2006, 08:26 PM
  #1  
TECH Regular
Thread Starter
iTrader: (8)
 
slowscott's Avatar
 
Join Date: Nov 2003
Posts: 439
Likes: 0
Received 0 Likes on 0 Posts
Default another duals question

What is the best way to pull back the rear carpet before drilling? I removed the rear seats but I can't see where to start pulling on the carpet.

Also, when I flip my fuel lines, do the lines come out of the plastic brackets and then just get pushed up? Or do the lines actually just twist over themselves?

Thanks
Old 07-17-2006, 08:33 PM
  #2  
ЯєŧąяĐ Єl¡m¡иąŧøя ™
iTrader: (18)
 
orangeapeel's Avatar
 
Join Date: Nov 2004
Location: Justin, TX
Posts: 16,083
Likes: 0
Received 4 Likes on 4 Posts

Default

Take out the back seats, and pull the carpet from above ontop of the gas tank area. It is a beatdown to do, but wprth it in the end.

Take the fuel lines out of the plastic holder. Flip the holder over and push the lines upward and clip them back in.
Old 07-17-2006, 08:40 PM
  #3  
TECH Regular
Thread Starter
iTrader: (8)
 
slowscott's Avatar
 
Join Date: Nov 2003
Posts: 439
Likes: 0
Received 0 Likes on 0 Posts
Default

Thanks thats exactly what i needed to know!
Old 07-17-2006, 08:56 PM
  #4  
ЯєŧąяĐ Єl¡m¡иąŧøя ™
iTrader: (18)
 
orangeapeel's Avatar
 
Join Date: Nov 2004
Location: Justin, TX
Posts: 16,083
Likes: 0
Received 4 Likes on 4 Posts

Default

Anytime!




All times are GMT -5. The time now is 01:40 AM.