Speed Density

iTrader: (38)

Ive posted this before but it was a long time ago.

My setup:

*396ci LT1
*280 @ .550
*23x/24x .6xx/.6xx
*Victor EFI


Will be seing a very large shot of nitrous too.

My question is, are my 1 3/4s still gona kick *** for the new build or should i look into some 7/8s?

orangeapeel

iTrader: (18)

For a stroker it couldn't hurt.

Speed Density

iTrader: (38)

True. But if its not going to be a noticable or reasonable gain then ill save the $600.

96lt1m6

iTrader: (31)

are the 1-7/8 stepped?
personally i would go with the bigger tubes,you will notice a differece especially if you spray it!

slow trap

iTrader: (22)

i agree.on a big shot of spray is where the 1 7/8 tubes will shine since you will be moving a huge amount of air at lower rpms.

Speed Density

iTrader: (38)

They would be stepped.

Tony.

Speed Density

iTrader: (38)

Upitty!

SiL3NtXWS6

iTrader: (17)

I saw a niiiice gain switching to 1 7/8 stepped to 2inch on my stroker motor.

No loss of low end at all.