Hugger Z

iTrader: (4)

Got some new Black Halo Headlight housings for my car and a HID conversion (8000k) from ledguages.com. The black housing make the car look sinister. These lights are AWESOME!!!!! They light up the road so much more than my stock lights did. They also have an Orange LED for the Halo but I am not done wiring those up yet so I will have to post more pics when I get those working. I did test the Halo's and they look SWEET!!! Enjoy.

Housings

Close up of Black Housing

Lights on in the Garage

Lights on at Night

greentahoe

iTrader: (2)

That looks awesome!

AKidsDreamZ28

beam cutoff?

looks good, as long as the cutoff is nice.

SpoldUP

iTrader: (1)

what is beam cut off?

AKidsDreamZ28

sorry, its the cutoff pattern of the lights.

it looks like the projector was put in a regular housing and would have the reflectors to bounce off of creating a light pattern that would blind oncoming traffic.

Hugger Z

iTrader: (4)

No cutoff that I know of. Stock Halo housings carefully aimed. I was careful to mark the stock locations on the garage door and kept the new housings aimed to the same location. I also did a test drive by my buddies house and he said there was no glare.

AKidsDreamZ28

thats what i was asking, any pics of it?

how much was the whole setup?

Hugger Z

iTrader: (4)

Here's the housings and you can also see where I mounted the Ballasts.
I got a package deal from Nathan (LS1_SS) at ledguages.com. Check out his website for pricing. You can PM him to ask about a deal. I went through Nathan because I had him change the LED in the Halo to Orange. If you want regular Halos, I have seen them on ebay.

Magnet

iTrader: (36)

looks amazing

StrobinSS

iTrader: (13)

Looks great. I got the HID's I just need to order the halo's already.

Hugger Z

iTrader: (4)

Thanks guys. I love these things. They light up the road so much more!!!!

LS1_SS

iTrader: (127)

Lookin good Tony!!!
-Nathan

Hugger Z

iTrader: (4)

Thanks Nathan. Quick question for you. If you look at the housing pictures in my previous post and focus on the plug from the stock headlights into the ballast, there is a littls plastic clip missing on the pass side. When I installed that one it pushed those white inserts up a bit and I realized that the plastic cover was missing. Is it possible to get one of those and just snap it on or do I need a whole new jumper wire? I want to make sure it stays together and does not pop out when I am driving. Thanks again. I can't wait to get the Halo's wired up! More pics will follow as soon as I get those working. Initially they will be spliced in to my DRL, but ultimately they will be connected via another fog light switch on the dash so I can turn them on and off when I want.

LS1_SS

iTrader: (127)

Tony - PM me your address and Ill get one in the mail for you. It just snaps on there! I usually check everything before it leaves but I must have missed that.
-Nathan

ls2 bait

iTrader: (11)

i really like hid's but hate how people dont use projectors with them. it blinds the **** out of people in oncoming traffic and u dont get they cutoff at the end of the beam.

Reject

iTrader: (24)

do you even need the high beams anymore?! super sweet setup

LS1 Terror

nice!!!!

AKidsDreamZ28

if you look above that is what i asked and he tested for glare, apparently having none.

if done right he wont have glare and since there are no projector housings for camaros this is the next best option.

props for a nice set up!

Hugger Z

iTrader: (4)

Thanks guys. So far no complaints or flashing from other drivers. I love these things! Every time it is dark and they are on, I am smiling!! I still can't get over how much better they light up the road. I am dabating adding this to my DD as well.......

1999 SS

iTrader: (3)

how hard is it to wire these things up?