Question about milling stock heads
#1
11Second Club
Thread Starter
iTrader: (3)
Join Date: Dec 2004
Location: Dallas (Richardson), TX, USA
Posts: 1,294
Likes: 0
Received 0 Likes
on
0 Posts
Question about milling stock heads
Hey all,
I have stock LS1 heads, and I'm considering milling them 0.030-0.040". Is there any good way to determine exactly how much this is going to decrease my combustion chamber size? I'm trying to figure out what my CR will be afterwards.
TIA.
I have stock LS1 heads, and I'm considering milling them 0.030-0.040". Is there any good way to determine exactly how much this is going to decrease my combustion chamber size? I'm trying to figure out what my CR will be afterwards.
TIA.