phoenix1987

iTrader: (3)

I have a few questions about my Cylinder Head install. I bought my Ls1 bare and have had to buy pretty much everything. Did these motors come with pushrod guide plates? Or do I just drop them into the hole and put the rocker on? Also, when I put the push rods in the hole, do I push them down till they stop, then put on the rocker and bolt it down?

This will be stock rockers with 918 springs and upgraded pushrods.

I do have a couple magazines and books on the subject, but they really don't answer these qusetions.


Thanks

kenp

iTrader: (9)

No pushrod guide plates from the factory.

There are lots of discussions about the correct way to torque the stock rocker assemblies. Try doing a search.

waterbug1999

iTrader: (3)

Try this and see if it answers some questions.

http://ls1howto.com/index.php?article=2