DOUBT IT

iTrader: (13)

Hey guys, I'm in the middle of my LS6 intake install, and found this on injectors 2 and 4...







Are these okay to go back in? I have no idea about what's fine when it comes to an injector. Please give an answer soon please guys.

Thanks in advance,
Allen

Country Boy

iTrader: (24)

did it run like that? If so, Id say stick them bank in for temp untill you can replace them.

LS1MCSS

iTrader: (18)

If you didn't plan on changing them, I say try it to see if they leak. The oring is what does the sealing and if it isn't damaged it should work. If they leak, they are easy to change.

mikep2002

iTrader: (10)

Question where did those missing pieces go???

otherwhitemeat

iTrader: (3)

i believe you dont need that parts of the injector on, the o-ring will seal regardless.......mine dont even have that ring

2fast4u2catch

iTrader: (1)

yeah im with mikep id be more worried about that piece floating around in my motor

DOUBT IT

iTrader: (13)

Thanks to all that replied. I figured it out with some thorough searching. I pulled what remained of them off on 2 and 4, oiled up the o-rings, and put it all back together.

I noticed that the bottom of the injector ports on the LS6 don't seem to have the little retainers like the LS1 intake does.

I vaccummed out the ports thoroughly and heard when the pieces got sucked into the tube. I made damn sure that I didn't have any stray pieces of plastic in the motor.

NVR_ENUF

iTrader: (13)

Yeah, its OK to run them like that. Those plastic wafers are just there to hold the O-rings on.