MUSTANGBRKR02

iTrader: (91)

hey guy's I'm looking for the line that goes from the front head to head the front anyone have a part number or know where i can get one?

thanks ahead of time!

MUSTANGBRKR02

iTrader: (91)

anyone even know what im talking about??

the_merv

iTrader: (88)

You are talking about the Steam line I assume.. custom make one, it will be cheaper, and work better.

MUSTANGBRKR02

iTrader: (91)

how would you do that with the custom fittings on the head?

sssalah

LT1 has the steam vent line connected to the back of the heads. LS1 has it in the front, and LS6 is bent differently. Which model you're asking about?

the_merv

iTrader: (88)

He has a LS1 in the sig.. go into the LS1 forum, we have a different line on our Engines. They might be able to help you there.

MUSTANGBRKR02

iTrader: (91)

i have a lt1 also that is why i am here

the_merv

iTrader: (88)

This is what I did with mine.

MUSTANGBRKR02

iTrader: (91)

what goes on the front ports then?

the_merv

iTrader: (88)

Block them.

MUSTANGBRKR02

iTrader: (91)

so nothing goes there?

the_merv

iTrader: (88)

No. The reason they are there is cause of the Casting. Since a Head is cast out of 1 mold, and them lines are on the same side, if you put only 1 side of the cast with a hole, it would end up opposite of each other when you put them on the Engine. I am suprised that they are out and not blocked. The fronts should be blocked.

MUSTANGBRKR02

iTrader: (91)

ahh thanks my first lt build and its not mine i wasn't there for the tear down so that is why i am so confused! thanks again! whenever i have a question you always seem to awnser it.

the_merv

iTrader: (88)

I am still wonderin how they got them plugs out of the Heads. They are in there, really in there, and no need to be removed..

MUSTANGBRKR02

iTrader: (91)

they are new trick flow heads

the_merv

iTrader: (88)

That's why..
Block the front 2 if plugs came with them.