Who can make me an intake elbow?
#1
On The Tree
Thread Starter
Who can make me an intake elbow?
I'm doing a rear drive conversion on an 87 Dodge Shelby Charger using a GM superchared 3800 from a 96 Park Ave Ultra(L67). Getting the engine mounts fabbed is not an issue (i'll get to that later if anyone is interested). What I need is an elbow to use on the back of the supercharger to get the throttlebody/MAF off the back of the engine,turn it 180 degrees facing forward. Who here would be able to make one or is there something out there I can use? Such as a 3" dia.(roughly) hard plastic elbow or a really tight radius mandrel tubing? I'm hooking this to a T-5 running to an independent rear from an 88 Pont. 6000STE with all wheel drive that is using a Ford 8.8 diff from a Thunderbird supercoupe(and hybrid cv shafts).
#4