Snow Dog

iTrader: (3)

I searched ad didn't find what I needed so if this is answered somewhere else simply point me in that direction. Thanks.

I am going to swap from a truck pan to an Fbody pan. I haven't even pulled the truck pan yet to see what's inside but I'd like to go ahead and start looking for the parts I need. Do I only need a new pan and pickup designed for an Fbpdy or do I need more than just that. Thanks.

JeepinBash

iTrader: (6)

you'l also need a windage tray for an f-body as the the front portion of the f-body oil pan is not deep enough to allow the use of a full length windage tray.

Brains

iTrader: (7)

.. or cut the truck windage tray down, either or.

Snow Dog

iTrader: (3)

I can cut metal. Is there anything in particular I need to watch out for, or just make sure the pan fits on without hitting the tray? Thanks

bczee

iTrader: (12)

Don't forget the Pickup tube.

The F-Body windage tray also has a baffel that is below the windage tray to keep the oil from going forward under braking.. I would suggest you also just use the F-Body Tray..

G-Body

iTrader: (4)

https://ls1tech.com/forums/showpost....20&postcount=6
You will need all the f-body parts, pan, windage tray, pickup, dipstick and tube

https://ls1tech.com/forums/showpost....86&postcount=5
Tray mods

Snow Dog

iTrader: (3)

Thanks guys. Next question, anyone happen to have all those parts for sale used? haha and so the search begins. Thanks

G-Body

iTrader: (4)

It took me a while to find an f-body pan used, they are difficult to find used because the f-body pan fits a lot mor conversions than the truck pan.

zmonsterjb

iTrader: (16)

do you have to use the baffel and windage tray?

Steve VanS

iTrader: (1)

Hi

I have a left-over '99 Camaro LS1 oil pan and pick-up if you'd like to buy it. We'd like $80.00 plus shipping ($ ~~ 10.00) Nice condition, I cleaned it up and sprayed it down with lots of WD40.

Email me at stevev@aint.com

76LQ9TA

iTrader: (1)

That's a good deal. I paid $240 for new gm. No one had used pans.

dman

iTrader: (5)

Steve, if the originator of this thread doesn't want it i'll take it.

Darin
dman344@yahoo.com

QSPres

iTrader: (15)

You can probably get away with a CTS-V pan if you can find one...

dman

iTrader: (5)

thanks Steve.