larsdahlberg

Hi,
does anyone know of anyone successfully mating an Audi Transaxle to an LS1?

There are lots of references on the net to that setup but I havn't been able to track anyone down

Kennedy Engineering says there is interference with the starter....

Any leads?
/Lars

stealth71

iTrader: (15)

Try advance adapters. They might not have exactly what you need, but can make anything or can point you in a better direction.

terryr

A quick google search;

http://www.bncproducts.com/

http://www.lambolounge.com/Chassis/T.../5000/5000.asp They say they use a kennedy with LT1.

Sabre002

iTrader: (7)

What Audi trans are you looking to put a LS1 to. Are you putting a LS1 into a Audi or using the trans for a kit car?

01WS6/tamu

iTrader: (37)

Why not just scrap it and run a 60 behind it. The driveshaft will be easier than trying to mate the two in compatible transmissions. Then if it dies when it's finished you are double screwed.

1dirtyZ

iTrader: (1)

this is giving me some naughty project ideas

Fuzzylogic

Tell me about it. There's a dead sexy '00 Audi wagon... A4 I believe, with a manual transmission, down the street. No engine.