Cadillac CTS-V - Mike Smith's ProCharged 402 CTS-V...

Just thought you guys might like to see how Mike's car is turning out...

http://www.ls1tech.com/forums/showthread.php?t=647134

Shane

I can't wait to see more.

Any vids in the works?

I am scrambling to get an F-1A in here so we can finish the engine side of this project, I am hoping to see 15# of boost at 6800 to 7000. I will get some video when we put it back on the dyno and then again when we get Mike down here to take it to No Problem Raceway...:drive: or maybe it will be me to take it on its first pass...:D

We are working on the cooling system today, its going to require a little reworking to make everything fit again. We are also waiting on the driveshaft so the new rear can go in. Other than that its just details. We have some Nexus gauges going in that match the CTS-V dash almost perfectly.

Shane

I'm on your six with a 427 :chug:

Tell me about the IRS?

I should be on your 12!

Uh and I will be on your 3! LOL
Parker my rear end is just about out! It's singing like a bird. Who should I send it to so I can fix it?

I'm on your six with a 427 :chug:

Tell me about the IRS?

Mike's car will be the 2nd recipient of the MADMAN 9" IRS. You can see the sticky above for details but Parker TX has one in now for I guess about 8 months. Once Mike's car is finished I will have firm pricing for this kit. We had to get a 10 piece production run on driveshaft flanges and half shafts to get any kind of price breaks so I hope we sell a few. For as much time as we have invested in this I need to sell 50!!! :eek2:

Shane

Mike's car will be the 2nd recipient of the MADMAN 9" IRS. You can see the sticky above for details but Parker TX has one in now for I guess about 8 months. Once Mike's car is finished I will have firm pricing for this kit. We had to get a 10 piece production run on driveshaft flanges and half shafts to get any kind of price breaks so I hope we sell a few. For as much time as we have invested in this I need to sell 50!!!

Please keep me in mind before I rip off Steve's (azp&s)'s Billet Dana 44 from his Viper :cry:

Thanks,
Chef

Uh and I will be on your 3! LOL
Parker my rear end is just about out! It's singing like a bird. Who should I send it to so I can fix it?


I would just take the plunge and get the 9" or a warrantied replacement.

Parker,
Will you email me and give me an idea of how long they may have it and a cost. I can't find anything on that.
dbouchillon@500fiko.com

when is the trip to no problem supposed to happen, id like to make a pass by and check the car out in person, you might end up with my car at your shop for a while too :devil:

when is the trip to no problem supposed to happen, id like to make a pass by and check the car out in person, you might end up with my car at your shop for a while too :devil:

We will be out there the weekend of Feb 22nd... :)

Also, we will have final pricing and lead times for the rear by then. It has been like pulling teeth to negotiate with our suppliers on cost for these low prodution runs. :bang:

sounds like fun... hope i can make it

Parker,
Will you email me and give me an idea of how long they may have it and a cost. I can't find anything on that.
dbouchillon@500fiko.com


Thunder stated they should have pricing the weekend of Feb. 22nd.