What size piping and WG/BOV
#1
Staging Lane
Thread Starter
iTrader: (-1)
Join Date: Oct 2005
Location: Ocean Springs, MS (Gulf Coast)
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
What size piping and WG/BOV
Going to make my own kit I decided. Just curious what size piping I need to run and what size WG and Bov. I decided that I am going to get a WG that release back into the exhaust. My setup is a 385ci LT1. Looking to run 20-24psi to make 1000rwhp. Its a GT47-88 turbo. If I cruise around town maybe on the weekends it will be set about 12psi. Is 2.5" piping to small? I was thinking that I should run a 3" dp or maybe 3.5"
#2
TECH Senior Member
iTrader: (21)
I run the 44mm Progate WG from Turbosmart and it dumps back into my DP.. I run a 5" DP of the turbo stepped down to 4" before the K-Member.
1 3/4 primaries from the headers to a 2 1/2" collector and both feed the Turbo.
3" piping from the turbo to the IC and mt ATI Race Ready Bypass before the IC.
Then 4" out of the IC to the TB
Kyle
1 3/4 primaries from the headers to a 2 1/2" collector and both feed the Turbo.
3" piping from the turbo to the IC and mt ATI Race Ready Bypass before the IC.
Then 4" out of the IC to the TB
Kyle
#3
Staging Lane
Thread Starter
iTrader: (-1)
Join Date: Oct 2005
Location: Ocean Springs, MS (Gulf Coast)
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by NA$TY-TA
I run the 44mm Progate WG from Turbosmart and it dumps back into my DP.. I run a 5" DP of the turbo stepped down to 4" before the K-Member.
1 3/4 primaries from the headers to a 2 1/2" collector and both feed the Turbo.
3" piping from the turbo to the IC and mt ATI Race Ready Bypass before the IC.
Then 4" out of the IC to the TB
Kyle
1 3/4 primaries from the headers to a 2 1/2" collector and both feed the Turbo.
3" piping from the turbo to the IC and mt ATI Race Ready Bypass before the IC.
Then 4" out of the IC to the TB
Kyle