Generation IV Internal Engine - O-ringed Block + Head Combo



PDA

View Full Version : O-ringed Block + Head Combo

Flow Wizard
02-09-2007, 09:58 AM
Anyone know what the max head bore that can be used on 4.045 o-ringed block?

I was going to use a set of 4.125 bore heads and wanted to know if there would be enough contact area between the blocks o-ring and the head gasket (4.125) to cut a receiver grove in.

Richard@WCCH
02-09-2007, 01:49 PM
What's the width of the O ring groove and what's the groove's center dia? I don't think there's one specific setup due to differing types of head gaskets.

Richard :)
Juiced
02-09-2007, 05:31 PM
richard can you cut the receiver groves into heads?

Richard@WCCH
02-09-2007, 06:41 PM
richard can you cut the receiver groves into heads?

Yes I could but but it'll be a long wait. I've got my hands full right now with a number of projects. What's your schedule?

Richard :)