Wheels & Tires Forged | Billet | Cast | Radials | Slicks

+35mm offset on 17x9 and lowered?

Thread Tools
 
Search this Thread
 
Old 02-09-2007, 06:44 PM
  #1  
11 Second Club
Thread Starter
iTrader: (21)
 
hallass's Avatar
 
Join Date: May 2006
Location: Hermitage, PA
Posts: 114
Likes: 0
Received 0 Likes on 0 Posts

Default +35mm offset on 17x9 and lowered?

i've seen a few cars running the sportmax 962 with no problems, but i haven't seen one yet that was lowered. my car is sitting on sportlines so it's pretty low and dunno if i wanna risk ordering the wheels and have the tires bashing my quarter panels up. anyone have these wheels in 17x9 and a lowered car?
Old 02-11-2007, 06:34 PM
  #2  
TECH Senior Member
iTrader: (2)
 
Xsta Z 28's Avatar
 
Join Date: Feb 2002
Location: Schaumburg, IL
Posts: 12,092
Likes: 0
Received 7 Likes on 7 Posts

Default

Up front all should be fine, but if you go too low the rear quarter lips most likely will need to be rolled.
Old 02-12-2007, 02:52 PM
  #3  
Launching!
iTrader: (1)
 
splitplug's Avatar
 
Join Date: May 2005
Location: Miami, FL
Posts: 235
Likes: 0
Received 0 Likes on 0 Posts
Default

I'm pretty sure the sportlines will be too low for those wheels. I currently have them (the Sportmax 962's) and from the looks, the rear might rub without the fenders rolled, but only going over bumps and stuff like that. The fronts look like they might, but I haven't really measured anything.

I am currently looking to lower my camaro an inch or so, but it's been sort of a pain figuring out what set up to get for this offset.

I love the wheels though.




All times are GMT -5. The time now is 10:32 PM.