remaining parts for sale...
#1
Banned
Thread Starter
iTrader: (4)
Join Date: Feb 2006
Location: FTW, TX
Posts: 2,665
Likes: 0
Received 0 Likes
on
0 Posts
remaining parts for sale...
Cam Motion (Spec'd by Allan Futral) 243/246 .632/.617 113 (used for dyno pulls then pulled) $250
TransKing "Race Prep" TH400, fully built with transbrake, rmvb and deep pan. $700
PTC TH400/350 PG (with turbo shaft) 9.5" 4800 RPM Nitrous Converter w/ Anti Balloning Plates etc. $650
T&D Shaft Mount LS1 Rocker Arms (solid or hydraulic roller), used and in perfect condition. $650
JAZ 10 Gallon poly cell with foam and -6AN in and out fittings. $110
"Race" seats, I have had these for two years and NEVER installed them or even sat in them that much really, they have just been in the shop in the way. $200+shipping for the set.
I have pictures of just about everything except the cam, injectors and converter right now however I can get those if nessecary. All prices are obo, lowball offers will not be acknowledged. Paypal prefered. I am available via pm here, or email at mtackel@charter.net or by phone at...
Matt
TransKing "Race Prep" TH400, fully built with transbrake, rmvb and deep pan. $700
PTC TH400/350 PG (with turbo shaft) 9.5" 4800 RPM Nitrous Converter w/ Anti Balloning Plates etc. $650
T&D Shaft Mount LS1 Rocker Arms (solid or hydraulic roller), used and in perfect condition. $650
JAZ 10 Gallon poly cell with foam and -6AN in and out fittings. $110
"Race" seats, I have had these for two years and NEVER installed them or even sat in them that much really, they have just been in the shop in the way. $200+shipping for the set.
I have pictures of just about everything except the cam, injectors and converter right now however I can get those if nessecary. All prices are obo, lowball offers will not be acknowledged. Paypal prefered. I am available via pm here, or email at mtackel@charter.net or by phone at...
Matt
#5
Banned
Thread Starter
iTrader: (4)
Join Date: Feb 2006
Location: FTW, TX
Posts: 2,665
Likes: 0
Received 0 Likes
on
0 Posts
the seats have a bracket but it doesn't match the same bolt holes. easily fixed with a piece of strap and a welder. OR, just remove you stock seat from its bracket and attach that bracket to this seat. ZIPZ28 has the same seats and hooked them to his power seat brackets.
Matt
Matt