02BEAST

iTrader: (8)

Does anyone have these or are they needed to prevent the y-pipe from banging the floor board.Can I do without them?

Hard Core Z28

The bump stop will help but adjusting the y pipe will be better.

Tainted

iTrader: (9)

you can get a cheap U clamp from auto zone or somewhere like that and run a peice of hose through it and use that. thats what im using and keeps it from banging but I'd still like to get the hanger since I still got some vibration

98Camarod

iTrader: (43)

thunder racing has them, they are made by mufflex.

00slowredz

i was just reading in another thread because im having the same problem....everyone was sayin that solid motor mounts will stop it

RedTA02

i hear bad things about solid motor mounts unless your strictly set up to race, Lots of vibrations. I had some exhaust wrap around where the pipe hits the floorboard and it worked the best. I got my mufflex bump-stop, just tryed to put it on and it sucks even worse than before. it seems to pull the y closer to the floorboard, any suggestions?