Harlan shift light wiring...
#1
TECH Addict
Thread Starter
iTrader: (15)
Join Date: Jun 2002
Location: IL
Posts: 2,642
Likes: 0
Received 0 Likes
on
0 Posts
Harlan shift light wiring...
Just wondering if any of the LTx guys, ran a Harlan Shift light..I was wondering how you had it wired up. The directions are mainly towards the LSx cars, but I wasn't sure if it pertained (sp?) to the LTx cars too..Pic of your light mounted would be cool too.
#2
On The Tree
iTrader: (6)
Join Date: Nov 2005
Location: west chester,pa
Posts: 120
Likes: 0
Received 0 Likes
on
0 Posts
I got one in my lt1 I got it wired up through my msd box. It's mounted in my a-pilar in the vent. I also seen them mounted in the heater vents. Sorry no pixs my car is over my brothers house.
#3
TECH Enthusiast
Join Date: Sep 2003
Location: bethel PA
Posts: 501
Likes: 0
Received 0 Likes
on
0 Posts
I have one in mine it just hooks up to the coil wire, I have mine in the piller to in the vent, if my web page wasnt down id post a pic for you, you can check my web page when its back up for a pic if you want.
sites back up
sites back up
#5
TECH Fanatic
iTrader: (3)
Join Date: Feb 2005
Location: Naples, FL
Posts: 1,118
Likes: 0
Received 0 Likes
on
0 Posts
Mine's in the same place as Lethal's. My MSD box is in the Glove box with the 2-step and module selector. I just ran the tach output from the box to the light. Then sourced power and ground at the fuse box below it. Fairly simple, works fine.