is it an issue?

Reply Subscribe

Thread Tools

Search this Thread

04-08-2007, 10:45 PM

otherwhitemeat

TECH Resident

Thread Starter

iTrader: (3)

Join Date: Oct 2006

Posts: 758

Likes: 2

Received 1 Like on 1 Post

is it an issue?

is it possible to run a 1 3/4 header on one side and a 1 5/8 header on the other side with a turbo charged motor and not have any problems?

Reply Like

04-08-2007, 10:50 PM

DMH Fabrication

FormerVendor

iTrader: (126)

Join Date: Dec 2004

Location: Richmond, VA

Posts: 1,399

Likes: 0

Received 0 Likes on 0 Posts

Why not just run the same size on both sides? It makes no sense to run two differnt size primary tubes.

Reply Like

04-08-2007, 11:18 PM

gogogadgetcar

TECH Apprentice

Join Date: Nov 2001

Location: malmstrom Air Force Base, Montana

Posts: 306

Likes: 0

Received 0 Likes on 0 Posts

if you have the capability to tune each cylinder ya sure you could pull it off probably but as stated above... why?

Reply Like

04-09-2007, 06:10 AM

engineermike

TECH Addict

Join Date: Jul 2005

Posts: 2,153

Likes: 0

Received 3 Likes on 3 Posts

Couldn't be any worse than running a tubular on one side and a log on the other and that works fine, even without the ability to tune each cylinder.

Mike

Reply Like

04-09-2007, 05:57 PM

otherwhitemeat

TECH Resident

Thread Starter

iTrader: (3)

Join Date: Oct 2006

Posts: 758

Likes: 2

Received 1 Like on 1 Post

Quote:

Originally Posted by engineermike

Couldn't be any worse than running a tubular on one side and a log on the other and that works fine, even without the ability to tune each cylinder.

Mike

ya thats what i figured too

Reply Like

04-17-2007, 05:03 PM

orange88

On The Tree

iTrader: (1)

Join Date: Aug 2005

Posts: 181

Likes: 0

Received 0 Likes on 0 Posts

what the hell are you rigging up now

Reply Like

04-17-2007, 05:04 PM

NHRAMAN

TECH Senior Member

iTrader: (1)

Join Date: Apr 2005

Location: Vancouver,[KITSILANO].B.C. Canada *WestCoast*

Posts: 8,810

Likes: 0

Received 0 Likes on 0 Posts

Quote:

Originally Posted by engineermike

Couldn't be any worse than running a tubular on one side and a log on the other and that works fine, even without the ability to tune each cylinder.

Mike

Can u run a stocker log manifold on 1 side..and a LT header on the other side.???

.....on my internally stock engine.[asking because emmissions MIGHT check location of cats--pass. side is fine.]

Reply Like

is it an issue?

is it an issue?

Trending Topics