Cam Swap - Gaskets?
04-12-2007, 08:09 PM
#1
12 Second Club
Thread Starter
iTrader: (5)
Join Date: Jun 2004
Location: Toronto
Posts: 509
Likes: 0
Received 0 Likes
on
0 Posts
Cam Swap - Gaskets? Swapping the cam on my car soon. Also taking the heads off to replace the lifters (and make it easier to do the springs while I am at it).
What Gaskets should I pick up?
Below is what is going in:
Camshaft
LS6 ported oil pump
LS2 timing chain
pushrods
springs
lifters
March UD pulley
Redtop SVOs
The engine has 120K on it.
Figure Id do the headgaskets while I have the heads off.
What else?
Thanks.
What Gaskets should I pick up?
Below is what is going in:
Camshaft
LS6 ported oil pump
LS2 timing chain
pushrods
springs
lifters
March UD pulley
Redtop SVOs
The engine has 120K on it.
Figure Id do the headgaskets while I have the heads off.
What else?
Thanks.
04-12-2007, 08:38 PM
#2
11 Second Club
Check "cam swap" link in my sig for my general advice. 2-3 years old but still good.
Need a new water pump gasket, valve cover gaskets are fine to re-use.
Don't forget both a longer crank bolt for installing the pulley and a brand new, unused crank bolt of proper/normal length for final in stallation.
Need a new water pump gasket, valve cover gaskets are fine to re-use.
Don't forget both a longer crank bolt for installing the pulley and a brand new, unused crank bolt of proper/normal length for final in stallation.
Last edited by blkZ28spt; 04-12-2007 at 09:48 PM.
