smokinHawk

iTrader: (48)

finished up welding the 4" pipe to the intercooler to throttle body, seemed to turn out ok
here are some pics
also included some pics of the 4" exhaust

HUNTER02SS

iTrader: (24)

Look's good from my house!Nice job.

onfire

iTrader: (17)

Looks like somebody is ready to make some power.

99Z28LS1

iTrader: (4)

damn thats clean, i like fab work, 1 of **** that no one has(not saying its never been done)

2002/Black/SS

iTrader: (3)

haha is 4" even needed???? that bigger then most exhausts

2001WS6Vert

Looks like your ready to go back to the track. I know that 88 can do better than high 11's.

Firechikn

iTrader: (15)

Is that a ford style radiator? Return on right side? Is the pick up on the left or right? That could be useful in my setup.

smokinHawk

iTrader: (48)

yes the return is on the driver side, and pick up on the left, its a griffin 19x22
the 4" intake piping is the same size as my 4" exhaust, 4" piping looks so pimp.

hopefully she will do a whole lot better then high 11's as next time she goes out she'll have some meaty stickies and a 3 speed with a brake.

98redorangeta

iTrader: (10)

Looks good man cant wait to see it go down the track hope fully my car will be getting going soon and i can go with you.

THE_SUPRA

looks nice!

im not knocking you at all. im sure you have much more experience than I, but wont that add quite a bit of lag?

cablebandit

iTrader: (37)

a millisecond i bet nice job!

THE_SUPRA

oh i was under the impression that it was fairly significant. thanks for correctiong me then.

Phil99vette

iTrader: (11)

Where did you get your bends from and do you bead the ends? Finished product looks great!

smokinHawk

iTrader: (48)

bought them used off of a guy with a 1000+RWHP single turbo viper as he had some left overs.
some of the ends are beaded, but not all as its hard to get the silicon and clamps on. i think the tbolt clamps wil hold pretty well, if not then ill bead them.