Generation III External Engine LS1 | LS6 | Bolt-Ons | Intakes | Exhaust | Ignition | Accessories
Sponsored by:
Sponsored by:

exhaust setup question

Thread Tools
 
Search this Thread
 
Old 04-28-2003, 12:38 AM
  #1  
Staging Lane
Thread Starter
 
FreightTrain3's Avatar
 
Join Date: Dec 2002
Location: Glen Burnie, Maryland
Posts: 88
Likes: 0
Received 0 Likes on 0 Posts
Default exhaust setup question

Hey guys, I got an idea for an exhaust on my car without havin to pay gmmg all the money. I wanna make a chambered exhaust with the use of an X pipe. I was thinkin about getting a stainless steel x pipe from http://www.exhaustproslinc.com and getting two chambered mufflers from sweet thunder. Now im not sure on the size of the mufflers to get, but I was thinkin about doing this from the cats back. Has anyone tried this with success and like it? Also, for advice, what length chambered muffler should I get? I was planing on putting the mufflers after the x pipe and run them over the axle and make it so it comes out where the tips normally exit in the rear.
Old 04-28-2003, 05:54 PM
  #2  
Staging Lane
Thread Starter
 
FreightTrain3's Avatar
 
Join Date: Dec 2002
Location: Glen Burnie, Maryland
Posts: 88
Likes: 0
Received 0 Likes on 0 Posts
Default Re: exhaust setup question

ttt




All times are GMT -5. The time now is 06:48 AM.