Mazda RX7/350
#1
TECH Resident
Thread Starter
iTrader: (1)
Join Date: Sep 2005
Location: Elko MN
Posts: 833
Likes: 0
Received 0 Likes
on
0 Posts
Mazda RX7/350
well i almost have my sbc RX7 done just a few smalls things to do like route wires, make sure fuel pressure is correct since we're using the factory fuel pump
the motor should be pretty strong
its a 350 bored .030 over with flattops with valve reliefs, vortec heads, which comes out to close to 9.5:1 compression, small cam 214 intake 224 exhaust, we're running a T-5 tranny with the stock 4.10's in the rear end i should have some pics here pretty soon, should be fun when i finally get it on the road
the motor should be pretty strong
its a 350 bored .030 over with flattops with valve reliefs, vortec heads, which comes out to close to 9.5:1 compression, small cam 214 intake 224 exhaust, we're running a T-5 tranny with the stock 4.10's in the rear end i should have some pics here pretty soon, should be fun when i finally get it on the road
#3
TECH Resident
iTrader: (3)
Join Date: Oct 2006
Location: edmonton alberta canada
Posts: 858
Likes: 0
Received 0 Likes
on
0 Posts
sounds similar to my old car mine was 11-1 with vortecs and a comp 274 and 1.6 rockers an air gap a 650 double pumper and a 200 shot through a 200r4 auto and a 3.90 lsd rear it ran 11.2@129mph with a horrible 60 ft