Help needed after header install.
06-09-2007, 09:40 AM
#1
Staging Lane
Thread Starter
iTrader: (3)
Join Date: Apr 2006
Location: Yukon, Ok
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Help needed after header install. I just recently did a header install on my trans am.. i have not had it tuned yet.. i have been experiencing one major problem...the car alot of times will not accelerate when i give it gas and then when i slam it it kicks in and runs fine at WOT. but if i start driving regular again it start to cut out again..any ideas or suggestions?
06-09-2007, 09:47 AM
#2
TECH Enthusiast
iTrader: (3)
Join Date: Apr 2004
Location: midland,nc
Posts: 511
Likes: 0
Received 0 Likes
on
0 Posts
probably not enough info on car. what year, etc.
sounds like something simple like a loose or burnt plug wire, or something that was nicked when the headers were installed.
may also want to try in the gen III sec.
rob
sounds like something simple like a loose or burnt plug wire, or something that was nicked when the headers were installed.
may also want to try in the gen III sec.
rob