Phoenix Gold Xenon 200.4 where to set x-overs?
06-10-2007, 12:50 PM
#1
Phoenix Gold Xenon 200.4 where to set x-overs? Ok I can shop and install but I dont really know how to tune a system. Where do I set the cross-overs/filters for on the amp? the rear is bridged for the sub and the fronts are running my 2 way door componants.
I know I want to filter out the highs from the sub and visa versa for the doors. Not running RAF at this time and if I do I'll run them straight from the HU. Speaker wires are run but I havent installed speakers, not sure if I'll need them.
Running a BA G5 10" sub and DA Hex S600s in the doors.
I know I want to filter out the highs from the sub and visa versa for the doors. Not running RAF at this time and if I do I'll run them straight from the HU. Speaker wires are run but I havent installed speakers, not sure if I'll need them.
Running a BA G5 10" sub and DA Hex S600s in the doors.
06-10-2007, 03:54 PM
#2
Good place to start as a high pass for the comps is 80 hz, and a good place to start for the low pass on the subs is also 80 hz.
You can tune it from there to your preference. Some people cross their subs are 120 hz, others cross at 50 hz and have strong midbass in the doors. I'd start at 80 and go from there though.
You can tune it from there to your preference. Some people cross their subs are 120 hz, others cross at 50 hz and have strong midbass in the doors. I'd start at 80 and go from there though.
